Thrust Bearing

F-code Section C-code PS S3.2 3540 Non-Braking Caster Wheel, RRX35/RSX40

Version no T-code 002 395/398

2. Thrust Bearing

2.1. Removal

1. Park the truck on a flat surface. 2.Turn key switch to OFF and disconnect battery at battery connector. Check to make sure battery retainer plates are in place. 3.Jack the rear of the truck. 4.Remove main electronic card panel. 5.Remove floor board.

NOTE! For models with brake on caster wheels, remove brake arm.

6.Bend tab down on lockwasher (2). 7.Remove locknut (1), lockwasher (2) and Nilos ring (3). 8.Inspect and replace bearings as needed.

F-code Section C-code PS S3.2 3540 Non-Braking Caster Wheel, RRX35/RSX40

Version no T-code 002 395/398

2.2. Installation

1. The truck must be properly blocked at this time. 2.Install the race (4) in caster pivot (13) and thrust bearing (14) on caster assembly. 3.Install caster assembly in caster pivot (13). 4.Install bearing (4), Nilos ring (3), lockwasher (2) and locknut (1). 5.Tighten locknut (1) while turning caster wheel assembly until tight, then back off 0.250 turn. 6.Bend lockwasher tab (2) up to secure locknut (1).

NOTE! For models with brake on caster wheels, remove brake arm.

7.Test caster operation.