F-code
Section
C-code
PS S3.2 3540 Non-Braking Caster Wheel, RRX35/RSX40 Version no
T-code
002
395/398
1. Caster Pivot 1.1. Removal 1. Park the truck on a flat surface. 2. Turn key switch to OFF and disconnect battery at battery connector. Check to make sure battery retainer plates are in place. 3. Jack the rear of truck (see page 66). 4. Remove the main electronic card panel (see page 103). 5. Remove floor board. WARNING Secure caster pivot before removing mounting bolts (20). Serious injury could occur if failure to comply with this requirement. 6. Turn and secure transmission to access mounting bolts (20). NOTE!
For models with a brake on caster wheels, the cable linkage must be disconnected before removal of foot pedal.
7. Bend lockwasher (2) tab down and remove locknut (1). 8. Remove Nilos ring (3) and bearing (4). 9. Remove caster assembly. 10. Loosen screws (5) to release spring tension. 11. Remove mounting bolts (20). 12. Remove caster pivot (13). Inspect and replace bushings and bearings as needed. 13. Installation 1. Install pivot block compartment first.
(16)
closest
to
battery
2. Install rear pivot block (16) on caster pivot (13). © BT Prime-Mover, Inc.
Return
Master Service Manual
2000-08-04
191
