CHAPTER 12 STORAGE At the end of the harvesting season it is suggested that the following steps be performed:
7.
Store the Harvester in a dry place where it is neither exposed to weather nor livestock.
1.
The Electrical Control Box should be stored in a dry place. Install the Dust Caps, where provided, over the ends of the Wire Harness Plug Connectors.
8.
Release tension on the Blower Drive Belt if the Harvester is going to be out of operation for a long period of time.
2.
Clean the Harvester thoroughly of all dirt, trash, excess grease and any other material that will absorb water and cause rust.
PROTECTION OF UNPAINTED SURFACES
3.
Thoroughly lubricate the Harvester as indicated in the Lubrication chapter.
4.
Clean and oil all Drive Chains.
5.
Paint all the parts from which the paint has been worn to prevent rust.
6.
Order and replace any required parts so the Harvester will be ready to operate the next season.
Apply a rust preventative oil or grease to the following unpainted surfaces: 1.
The Front Telescoping Drive Yoke Hub at the PTO drive end.
2.
The Front Bevel Gearbox Shaft Splines.
3.
All Drive Chains and Sprockets.
4.
The Length–of–Cut Sprocket Splined Shaft.
85
