VIII. SERVICE AND MAINTENANCE TOE-IN are removed.
To correctly gauge toe-in, use a tape measure placed at one-half tire height on the front center
Difficulty steering one way versus the other
seam of the front tire compared to the same
may also indicate incorrect toe-in and may require
measurement of the rear of the front tire (subtract
adjustment. For further assistance regarding toe-in
the front measurement from the rear measurement
measurement and adjustment, contact the Hagie
- it must be a positive number). Correct toe-in
Customer Support Department.
should fall somewhere between one half and three
NOTE:
quarters of an inch.
See page 98 for instructions on adjusting
Toe-in is pre-set at the factory and should not
toe-in. See also page 32 for information on
have to be adjusted unless the steering cylinders
recalibrating self-centering cylinders.
11 9 ½
EXAMPLE OF CORRECT TOE-IN FOR A MACHINE WITH 120 INCH TREAD WIDTH. (MUST HAVE ½" TO ¾" TOE-IN.)
120"
FIG 8.52
