IV. PREPARING TO OPERATE ATTACHING LS SYSTEM AND DEPTH COMMAND 1. Install Tasseltrol®/LS sensor mount support
wire diagram in the Hagie 204 Parts Manual.
weldment with the two nylon washers (fig 4.27,
4. Turn the ignition key switch to the “ON” posi-
item 2) in the forward- most hole of the tool bar
tion to check the sensor installation. DO NOT
(fig. 4.27, item 1).
start the engine. See page 55 for more infor-
2. Install the Tasseltrol®/LS sensor mount weld-
mation about the LS sensor assembly.
ment (fig. 4.27, item 3) to the sensor mount
5. Attach the depth command actuator (fig. 4.28)
support arm.
to the light sensor mount and the tool bar.
3. Install the cable assembly according to the
1
3
Tool Bar
2
FIG 4.27
NOTE: Over tightening of the sensor arm pivot mounting bolt (fig. 4.27, item 1) may cause the actuator to stall. FIG 4.28
34
PREPARING TO OPERATE
