IV. PREPARING TO OPERATE CUTTERS CONTINUED
Blade Rotation Right of Operator Hydraulic hoses on cutter heads should be hooked up so blades on heads mounted right of operator rotate according to fig. 4.22, fig. 4.25 and fig. 4.26 (clockwise from above). Refer to the Hagie 204 Parts Manual for correct hardware, hose lengths, and hydraulic
FIG 4.22
schematic.
NOTE: nt fro
Care should be taken when installing check valve (fig. 4.25, item 1) on cutter motor so the flow arrow is oriented correctly (twohead or three-head series).
IMPORTANT: Case drain hoses must be installed correctly on cutter motors to prevent
1
motor damage. Refer to parts manual. ( fig. 4.22)
TWO-HEAD SERIES FIG 4.25
nt fro nt fro
THREE-HEAD SERIES FIG 4.26
33
PREPARING TO OPERATE CONTINUED
