Index of Error Messages Error Message List Error Messages
Check or do the following in sequence:
Stuck Key
See “Keyboard or Auxiliary Input Device Check” on page 92.
System CMOS checksum bad - Default configuration used
T
Real time clock error
T
T
T T
Previous boot incomplete - Default configuration used
T T T
Invalid System Configuration Data
T T
Operating system not found
T T T T
Power-on indicator turns off and LCD is blank.
T T T T
Power-on indicator turns on and LCD is blank.
T T T T T T T
Power-on indicator turns on and LCD is blank. But you can see POST on an external CRT.
T T T T T
Power-on indicator turns on and a blinking cursor shown on LCD during POST.
T
Failure Fixed Disk
T
T
T T T
96
RTC battery. Run the BIOS Setup Utility to reconfigure the system time, then reboot system. RTC battery Run the BIOS Setup Utility to reconfigure system time, then reboot system. Mainboard Run “Load Setup Defaults” in BIOS Setup Utility. RTC battery Mainboard Run “Load Setup Defaults” in BIOS Setup Utility. Mainboard Run the BIOS Setup Utility to check if the fixed disk and drive A are properly identified. CD/DVD-ROM drive Hard disk drive Mainboard Power source (battery pack and power adapter.) See “Power System Check” on page 93. Ensure every connector is connected tightly and correctly. Reconnect the DIMM Mainboard Power source (battery pack and power adapter.) See “Power System Check” on page 93. Reconnect the LCD connector Hard disk drive LCD cable LCD inverter LCD Mainboard Reconnect the LCD connectors. LCD cable LCD inverter LCD Mainboard Ensure every connector is connected tightly and correctly. Mainboard Reconnect the hard disk drive connector. Run “Load Setup Defaults” in BIOS Setup Utility. Hard disk drive Mainboard
Chapter 4
