Jetta 2005 ➤ Body Repairs - Edition 04.2009
7.2
Installing
7.2.1
Preparing new part
Replacement part ♦ C-pillar reinforcement – Transfer parting cut to the new part and cut (when doing this take 10 mm additional material for overlap into consideration -shaded area-). – Step -shaded area- on new part.
es, in part or in w l purpos hole ercia , is n m ot p om c r erm o e t a itte riv du p or nl f e g n
rrectness of i t to the co nform spec at i h re o n wit in t his
7.2.2
ility ab y li an pt ce
AG. Volkswagen AG d agen oes ksw not l o gu yV b ara d e nte is r o eo h ut ra a c s s
Welding in
– Fit new part and secure.
– Weld parting cut, SG continuous weld seam (staggered). – Weld original joint, RP spot weld seam. – Install side panel ⇒ “6.2 Installing”, page 205 .
ht rig py Co t.
agen lksw Vo by
AG.
Prote cted by c o py rig ht . C op yi
Rep. Gr.53 - Body - rear
do c um en
212
