CNH Leica Geosystems Moldboard 800C 836C 836C AWD 856C 856C AWD F156.8A Motor Instructions Manual

Page 16

4 - ASSEMBLY

7. Install the socket tee (23) on the T-fitting installed on the hydraulic tank. 8. Pass the hose (11) through the right-hand side of the engine compartment. Connect the hose (11) and the hose (X) to the socket tee (23), as shown in figure 6.

LEIL16GRD0023AB

6

LEIL16GRD0024AB

7

LEIL16GRD0025AB

8

9. Connect the hydraulic hose (17) to the hydraulic connector (4) installed on the blade control valve (2).

10. Disconnect the hose (V) from the port “X” (pilot pressure port) of the hydraulic pump.

16 EN

Turn static files into dynamic content formats.

Create a flipbook

Articles inside

Insulate the battery terminals

1min
page 20

Remove the three screws with the relevant washers

1min
page 21

Locate the batteries the right - hand side the ma chine. Remove the four screws (R) with the relevant washers and nuts. Remove the battery cover (S) .

1min
page 16

Disconnect the positive terminal the battery

1min
page 19

Remove the six bolts (T) . Remove the cover (U) the top the front frame.

1min
page 15

Remove the jumper cable between the batteries

1min
page 18

Remove the bolts (N) with the relevant washers and nuts. Remove the bolt (P) with the relevant washer . Remove the cover assembly (Q) the front frame.

1min
page 14

Remove the side panels (K) from the cab floor

1min
page 12

Disconnect the negative terminal the battery

1min
page 17

Loosen the mounting bolts (L) and remove the cover (M) the hydraulic lines.

1min
page 13
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.