Loosen the mounting bolts (L) and remove the cover (M) the hydraulic lines.

from CNH Leica Geosystems Moldboard 800C 836C 836C AWD 856C 856C AWD F156.8A Motor Instructions Manual

Insulate the battery terminals

Hydraulic tank drain W ARNING

Chemical hazard! When handling fuel, lubricants, and other service chemicals, follow the manufacturer's instructions. W ear Personal Protective Equipment (PPE) instructed. not smoke use open flame. Collect fluids proper containers. Obey all local and environmental regulations when disposing chemicals. Failure comply could result death serious injury .

W0371A

23. Locate the drain valve the bottom the hydraulic tank, the rear right - hand side the machine. Place a suitable container for waste oil under the drain valve. 24. Unscrew the protective cap from the drain valve.

Screw a suitable drain hose. The valve opens and the hydraulic oil drains away . 25. After the hydraulic oil has drained away , unscrew the drain hose; the valve closes automatically . Screw the protective cap back in place.

LEIL16GRD0012BB 16

Loosen the mounting bolts (L) and remove the cover (M) the hydraulic lines.

Next Article

Insulate the battery terminals

Hydraulic tank drain W ARNING

W0371A

More articles from this publication:

Insulate the battery terminals

Remove the three screws with the relevant washers

Locate the batteries the right - hand side the ma chine. Remove the four screws (R) with the relevant washers and nuts. Remove the battery cover (S) .

Disconnect the positive terminal the battery

Remove the six bolts (T) . Remove the cover (U) the top the front frame.

Remove the jumper cable between the batteries

Remove the bolts (N) with the relevant washers and nuts. Remove the bolt (P) with the relevant washer . Remove the cover assembly (Q) the front frame.

Remove the side panels (K) from the cab floor

Disconnect the negative terminal the battery

This article is from:

CNH Leica Geosystems Moldboard 800C 836C 836C AWD 856C 856C AWD F156.8A Motor Instructions Manual