Electrical system – 5000 Parameters & adjustments Order number 235568-040
Date 2006-04-10
Valid from serial number 904526-
T-code 795
10.10 Parameters & adjustments 10.10.1 General The truck’s control system stores a number of parameters. These parameters are used to configure the truck for correct operation in the particular application for which it was designed. The parameters are adjusted using the hand terminal.
10.10.2 Adjusting parameters To adjust a parameter use the PARAMETER CHANGE function in the hand terminal: • Connect hand terminal. See “ Connecting the hand terminal” on page 23. VALUE NOT CHANGE CHANGED
ARE YOU SURE ? YES=ENTER NO= OUT
VALUE CHANGED
CHECK UP HOURS
0-9
CHECK UP TYPE ROLL SEM-X 24v
75A
V.. 00000
*
CHECK UP DONE CUTBACK SPEED 3
0-9
INVERSION BRAKING
0-9
RELEASE BRAKING
ENTER
DECELER DELAY
MAIN MENU * PARAMETER CHANGE
0-3 OFF
ENTER ACC.DELAY
OUT
0-9 0-9 0-9
ROLL = CHOOSE PARAMETER PARAM SET = CHANGE VALUE
• Select PARAMETER CHANGE from the menu and press ENTER. • Press ROLL buttons to display the required parameter. • Adjust the setting of the parameter with the PARAM SET buttons. • Press OUT followed by ENTER to store the new parameter setting or. • Press OUT followed by OUT to return to the main menu without changing the existing parameter setting. NOTE! Truck handling. Modifying specific truck parameters will change the driving characteristics of the truck. Do not change any parameters without the necessary know how.
© TIEE SARL
Service Manual
SP10, SP10S
10- 33
