Drive unit/drive gear – 2000 Service and repairs T-code 795
Valid from serial number 904526-
Date 2006-04-10
Order number 235568-040
7.2 Service and repairs 7.2.1 Dismantling the motor from the truck • Shutdown the truck, pull out the plug from the start block. • Remove the hoods from the battery compartment. • Loosen the battery connections. • Lift out the batteries. • Loosen the two screws holding the instrument panel. • Place the instrument panel in the truck. • Seal the oil-filling plug. • Loosen the connections on the tiller arm. • Dismantle the cover plate and the two nuts on the tiller arm. • Lift off the tiller arm. • Place the truck on its side. • Loosen the four bolts on the motor’s chassis mounting. • Carefully lift out the motor and place on a clean surface. Essential service and repair work can now be carried out on the motor. • Assembly takes place in the reverse order.
7.2.2 Inspection/replacement of the carbon brushes • Shut down the truck, pull out the plug from the start block. • Remove the hoods from the battery compartment. • Loosen the battery connections. • Lift out the batteries. • Loosen the two screws holding the instrument panel. • Place the instrument panel in the truck. • Seal the oil-filling plug. • Refit the instrument panel. • Place the truck on its side. • Dismantle the covers from the carbon brushes. • Loosen the cable connections are push back the carbon brush springs. • Pull out the carbon brushes and inspect/measure the wear. (See table) • Assembly takes place in the reverse order. 7- 2
Service Manual
SP10, SP10S
© TIEE SARL
