Installation and maintenance instructions – P1 Introduction, maintenance T-code 497
Valid from serial number 723984-
Date 2005-11-04
Order number 222996-040
• Bear in mind that the oil in the transmission and hydraulic system can be hot. WARNING! Risk of burn injuries Hot transmission and hydraulic oil. Let the truck cool before changing the oil.
• Only new and clean oil may be used in the hydraulic system. WARNING! The hydraulic system can be damaged. Hydraulic components can be damaged, if the oil is contaminated. Always use new and clean oil in the hydraulic system.
• Store and transport changed oil according to applicable local directions. • Do not flush solvents and the like used for cleaning down drains that are not intended for this purpose. Follow local directions that apply for destruction. • Disconnect the battery when welding on the truck. NOTE! The battery can be damaged. When using electric welding equipment, the welding current can enter the battery. The battery must be disconnected.
• Remove at least 100 mm of paint around the welding/grinding area using sand blasting equipment or paint remover when welding or grinding on painted surfaces. CAUTION! Unhealthy gases. Heated paint gives off unhealthy gases Remove 100 mm of paint from around the working area.
3.2.2 Cleaning and washing Cleaning and washing the truck is a significant measure for the reliability of the truck. • Carry out general cleaning and washing each week. NOTE! Risk of short-circuiting. The electrical system can be damaged. Disconnect the battery before washing by pulling out the battery plug.
3- 6
Service Manual
7PLL24
© TIEE SARL
