Electrical systems – 5000

13.3.6 Neutral speed reduction on slopes

If the driver release the speed leaver (L1) on a slope and the truck doesn’t come to a stop within a certain time the electrical brake will be applied.

13.3.7 Braking

The brake is always applied when the truck is started with the tiller arm in it’s upper or lower position (S10 open). The brake is released in the same moment as the conditions for driving are fulfilled and the truck starts to move.

Conditions to brake the truck:

•S10 open or S19 open.

13.3.8 Lifting the forks

•S34 activated.

•S31 closed.

•Battery status ok (if battery capacity >20% left).

13.3.9

Lowering the forks

•S41activated.

13.3.10 Horn

•S18 activated.

13.4 Hour meter

•Press S18 and turn S17 to on at the same time.

•Press S18 until you read the H= hour meters.

•You have now choosen H=hourmeters the symbol “B” will be highlighted.

•You can now choose type of hourmeter by pressing L1.

1(A)= Key time.

2(b)= Drive motor time.

3(c)= Pump motor time.

4(d)= Activity time.

5(s)= Time left to make service.

13.5 Error codes

•Press and hold S18 while turning S17 to “ON” position.

•Press and hold S18 until E = error codes is displayed.

•When E is selected, the “E” symbol will light up as an indication of what is shown in the display.

•The 50 most recent error codes are stored. The latest error is displayed first. The display shows the error code first, followed by the time when the error occurred.

•The error codes are divided into two groups, C = caution and E = error.

•C codes are not stored. They are only cautions and remain lit in the display as long as the fault remains.

•If there is only one error registered in the memory, the other empty entry lines appear as follows: Error: E - - - and time: - - - - .

Code C3

Description TLS: Shock sensors registered values outside the limits

Possible error cause

A shock sensor has reported values that exceed the truck’s tolerance values.

Driving may be too hard

Check that the shock sensor’s limit values are correctly set.

Check that the shock sensor is correctly positioned./The brake engages and stops the truck. The TLS reset command activates the truck