Figure 53-installing Cylinder Sleeve
2. Using a number 220 grit stone at a drill speed of 250-450 rpm, pass a hone througb tbe sleeve bore not more than 10 times to roughen up the bore. This promotes hetter ring seating and also "trues up" the sleeve.
Cylinder Sleeve Installation:
1. Clean the cylinder counterbore thoroughly before installing sleeves. Assemble Cylinder Sleeve Installer FT-910 and a new sleeve on the cylinder block as shown in Figure 53. Turn the screw clockwise until the sleeve is bottomed in the oounterbore.
3. Fit the pistons in the cylinder block as detailed in paragraph E.
MAIN BEARINGS, BALANCER~ FLYWHEEL AND CRANKSHAFr tween the engine and transmission. The engine must be removed before removing the crankshaft.
The main bearings and balancer can be replaced with the engine in the tractor. The flyWheel can be removed by removing the engine or by splitting the tractor be-
23
