WATER PUMP

3. Carefully lower the grille into position on the tractor and install the six attaching bolts.

4. Connect the hose to each side of the reservoir.

Install the medallion in the grille.

5. Connect the headlamps to the headlamp wiring harness. Install the grille door in the grille. 6. Secure the hood to the grille with the six rubber insulators and bolts.

7. Fill the cooling system with the proper coolant. 8. Fill the hydraulic reservoir to the proper level with M2C41 oil.

9. Start the engine and check for leaks.

ATER PUMP

The water pump used on the Ford Tractors requires no lubrication. The bearing used in the pump is integral with the pump shaft.

A repair kit is available for servicing the pump. Figure 3 shows the pump disassembled.

A. Removal

1. Drain the radiator. Loosen the hose clamp at the pump end of the hose, and pun the hose off the casting. 2. Remove the fan belt adjustment strap bolt, then remove the belt. 3. Remove the fan attaching bolts and lockwashers then remove the fan. 4. Remove the water pump attaching bolts and lockwashers. Remove the pump and gasket.

HOUSING

B. Disassembly

1. Remove the pump cover and cover gasket,

Figure 3. 2. Remove the pulley from the shaft with Remover 8501-DD-2. 3. Remove the bearing retainer. 4. Press the shaft and bearing assembly out of the impeller and pump body, as shown in Figure 4.

Use a suitable adapter or plate to hold the pump body in the position shown. 5. Remove the seal from the pump body by driving it toward the impeller end of the pump.

C. Assemhly

1. Press the shaft and bearing assembly into the housing as shown in Figure 5. Position the retaining dip groove so that it is aligned with the groove in the housing. Install the bearing retainer,

Figure 3, on the bearing.

?UM? COVER

Figure 3- Water Pump Disassembled

figure 4-Removing Wa'er Pump Shoft and 8earing