2550
43
WIPER Should visibility be unsatisfactory as a result of faulty wiper blade operation, clean rubber blades using a specific detergent or alcohol. Should faulty operation persist after cleaning, change the blades. For this purpose, proceed as follows: - tilt the arm assembly C lifting it from the windshield; - loosen screws D and pull-out the blade.
L. 037
Open the right rear side panel to check the level and refill reservoir with windshield solvent.
C
D 8418
D255-2M075
If spray pattern is defective, clean nozzle orifices with a needle. If necessary, re-adjust spray nozzle orientation so that the fluid will strike the windshield at top of the wiper sweep arc.
Important – When the ambient temperature decreases to 0 °C (32 °F) and below, always use an antifreeze type washer solution.
Study SAFETY RULES in the front of this manual thoroughly for the protection of machine and safety of personnel
