Wiper

WIPER

Should visibility be unsatisfactory as a result of faulty wiper blade operation, clean rubber blades using a specific detergent or alcohol. Should faulty operation persist after cleaning, change the blades. For this purpose, proceed as follows: - tilt the arm assembly C lifting it from the windshield; - loosen screws D and pull-out the blade.

C

L. 037

Open the right rear side panel to check the level and refill reservoir with windshield solvent.

D

8418

If spray pattern is defective, clean nozzle orifices with a needle. If necessary, re-adjust spray nozzle orientation so that the fluid will strike the windshield at top of the wiper sweep arc.

D255-2M075

Important – When the ambient temperature decreases to 0 °C (32 °F) and below, always use an antifreeze type washer solution.

Study SAFETY RULES in the front of this manual thoroughly for the protection of machine and safety of personnel