Every 100 hours

3. BEVEL GEAR/STEERING CLUTCHES AND

BRAKES - Check oil level Remove the rear cover of the transmission housing as described in page 56, unscrew the plug indicated, pull the dipstick underneath and check that the oil level reaches the line etched on it. If necessary top-up with oil through the plug hole. 5. HYDRAULIC SYSTEM - Check oil level

WARNING

Fluid under pressure: turn cap slowly to relieve pressure before removing it.

Check that the oil level is between sight gauge A (max. level) and gauge B (Min. level). This check must be done with machine on a flat surface, cold oil and engine idling. If the level appears through lower gauge B, remove the filler cap D and top-up until the level appears through upper gauge A.

D255-2M080

4. SIDE FINAL DRIVES - Check oil level Check that oil level reaches the plug indicated by the arrow (one plug to each final drive case); add oil through the plug hole, if necessary.

D255-2M038

Study SAFETY RULES in the front of this manual thoroughly for the protection of machine and safety of personnel