RIPP Supercharger JEEP Wrangler 3.8
STEP (10): Installing Supercharger bracket
Installing the supercharger bracket requires you to remove the factory water pump pulley To do so use a half inch ratchet and insert it into the tensioner adjustment slot Pull up with the ratchet to create more tension Using a 13mm box wrench loosen bolts on water pump pulley
Next press down on the tensioner and remove the factory belt and set aside.
Using supplied hardware install front side of bracket as imaged Once all hardware is started by hand tighten down evenly until all hardware is bottomed and then finish tightening to factory specs. 10
Copyright RIPP Modifications LLC 2008 all rights reserved
