10 Install SDS Bracket

RIPP Supercharger JEEP Wrangler 3.8

STEP (10): Installing Supercharger bracket

 Installing the supercharger bracket requires you to remove the factory water pump pulley  To do so use a half inch ratchet and insert it into the tensioner adjustment slot  Pull up with the ratchet to create more tension  Using a 13mm box wrench loosen bolts on water pump pulley

 Next press down on the tensioner and remove the factory belt and set aside.

 Using supplied hardware install front side of bracket as imaged  Once all hardware is started by hand tighten down evenly until all hardware is bottomed and then finish tightening to factory specs.

10