1 minute read
Octane Switch
Optional: Hooking up the Switchable Octane Mapping:
Your RIPP Black Box comes preprogrammed with the lower octane mapping as standard. This is not the most powerful of maps but rather more conservative. Although 87 octane can be used, we suggest using 89 as a minimum or low octane. Maps can only be switched with the key in the off position. Switching while the ECU is on will trigger lights
6spd: Located on the drivers side of the fire wall there is a small rubber grommet under the main wiring harness. Poke a hole in the grommet and run the gray wire through it. From inside looking up you can feed the wire and it will come down into the driver’s foot well. Feed the wire tight to the driver’s side over the electronic components. Remove the dash cover that faces the driver’s door and feed the wire up to this location.
Please note: If your engine compartment is subjected to excessive water, ice or mud, we would recommend installing all electronics in the passenger compartment following the automatic transmission guidelines: (Attention Critical Step)
Black Box Methanol injection controller Map Sensor
