Chapter 13 – Troubleshooting
AUTOMATIC TWINE WRAP SYSTEM TROUBLESHOOTING (Cont.) PROBLEM The word “tIE” is continuously displayed in the Control Box Digital Display while operating in the AUTO mode. (Continued)
Tie system will not start automatically.
Tailgate OPEN/CLOSED Indicators do not function on Digital Display.
Tailgate “OPEN” “GATE” message continues to flash on Digital Display after a bale has been discharged.
907520/CP0600
CAUSE
REMEDY
Faulty Harness.
Check for continuity in Harness.
End Wrap Pause Switch is faulty.
Check for faulty End Wrap Pause Switch; Switch must close as the Magnet passes by.
Mode Switch is set to MANUAL.
Set Mode Switch Fig. 30, Ref. 1 to AUTO.
Trip Magnet is not activating the Bale Size Switch.
As the bale grows to the desired size, the Trip Magnet MUST slide within 1/8 inch (3.2 mm) of the Bale Size Switch (3/16–3/8 inch (4.8–9.5 mm) on Early Style Baler Control). If necessary, adjust Magnet to proper location in slot and make sure the Switch is mounted in the proper location. Refer to the Adjustments chapter.
Bale Size Switch is faulty.
Check for faulty Bale Size Switch; Switch must close when the Magnet is near the Switch.
The Magnet on the Tailgate Switch Assembly is not properly adjusted.
Adjust the Magnet on the Tailgate Switch Assembly so that it passes within 3/32 inch (2.4 mm) from the Switch.
Tailgate Switch is faulty.
Check for faulty Tailgate Switch; Switch must close as the Magnet passes by.
The Magnet on the Tailgate Switch Assembly is not properly adjusted.
Adjust the Magnet on the Tailgate Switch Assembly so that it passes within 3/32 inch (2.4 mm) from the Switch.
Tailgate Switch is faulty.
Check for faulty Tailgate Switch; Switch must close as the Magnet passes by.
112
Printed in U.S.A.
