Maintenance ATTACHING DISK GANGS TO STANDARDS
CAUTION: Use suitable lifting devices or support stands to prevent disk from falling. Block disk gang when not rolling it into place. Wear gloves and other safety equipment to avoid injury. Where lifting facilities are available: 1. Position front gang assembly with concave side of disks to right, as viewed from the rear. 2. Position rear gang assembly with concave side of disks to left, as viewed from the rear. 3. Place gang carriers on corresponding gang assemblies and attach to bearing standards with bearing hex bolts, hex jam nuts, hex nuts and bearing wear plates. Where lifting facilities are limited: 1. Position gang carriers upside down. Place gang assemblies on gang carriers and attach to bearing standards with bearing hex bolts, hex jam nuts, hex nuts and bearing wear plates. 2. Turn completed assemblies of gangs and gang carrier right side up.
