Controls 4WD Engagement Lever This lever is located on L.H side of operator’s seat. It is used to engage or disengage the drive to front wheels and is recommended to be done in tractor stand still condition. 1. Depress the clutch pedal and stop the tractor motion completely. 2. Lift the lever (A) upwards to engage the drive. 3. Press the lever (A) down to disengage the drive.
Brake Two independent brake pedals are provided for L.H and R.H wheel braking to enable sharp turns during field operations. Depress L.H brake pedal (A) to make a sharp turn to left. Depress R.H brake pedal (B) to make a sharp turn to right.
Do not engage or disengage the 4WD Engagement lever while the tractor is in motion.
The brakes can be latched together to act simultaneously by means of brake pedal latch (C) as follows, 1 Rotate brake pedal latch (C) clockwise until it locks into R.H. brake pedal (B) 2. Depress either brake pedal to slow or stop the tractor. 3. When brakes are applied with brake pedals latched together, the tractor should stop in a straight line. Check and adjust brake settings if the tractor is dragged to either side on applying brakes. The Hand Throttle Lever should be brought to low idle rpm position before applying brakes.
A
B
C
Using unlocked brakes to stop the tractor at high speeds may cause accidental turning or tipping. Lock pedals together when not using the turn brakes or for road travel Slow down before making a turn. Do not apply independent brakes while an attachment is engaged with the ground. This can cause damage to the attachment , three point linkage of tractor and may also result in tipping of the tractor. 36 Model 25 25 4WD OPM/Sep-07
