LUBRICATION
TRAVEL REDUCTION GEAR SERVICE SPECIFICATIONS Oil level check ............................................................................... Every 250 hours Oil change ................................................................................... Every 1000 hours (after the first 250 hours of operation) Oil capacity (per reduction gear) CX130 and CX160 ......................3 litres (0.8 gal) Oil type ..........................................................................See “Fluids and lubricants”
LEVEL STEP 1
STEP 4
Park the machine on flat, horizontal ground.
2
2
1
CD00E166
Move the machine so that plug (1) is in the lowest possible position.
Remove the plug (2) and check the oil level. The level must come up to the lower edge of the orifice. If necessary, remove plug (3) and add oil through orifice (3) until the level comes up to the bottom edge of orifice (2).
STEP 3
STEP 5
Stop the engine and remove the starter switch key.
Install plugs (2) and (3).
CD00E166
STEP 6 Repeat Steps 2 to 5 for the other travel reduction gear. STEP 7 Travel slowly with the machine and make sure there are no leaks.
175
TRIM THIS EDGE RIGHT PAGE Bur 6-25930
TRIM THIS EDGE
STEP 2
