LUBRICATION
RINSING STEP 1
STEP 2
Close the drain valve once the radiator is completely empty. Close the plug on the engine block. Fill the system with clean water. Install the radiator cap. STEP 2 Start and run the engine at a speed slightly higher than low idle for ten minutes to bring the engine temperature to approximately 80°C. STEP 3
BD00M223
Drain the system once more. STEP 4 Repeat Steps 1 to 3 until the water drained is clear.
IMPORTANT: Use the correct coolant solution. STEP 3 Run the engine at idle speed for about five minutes. Add coolant solution if the level in the expansion reservoir drops.
FILLING STEP 1
IMPORTANT: Do not fill the expansion reservoir above the “FULL” mark.
CD00E171
Fill with coolant solution via the radiator until overflowing and install the radiator cap.
151
TRIM THIS EDGE RIGHT PAGE Bur 6-25930
TRIM THIS EDGE
Fill the expansion reservoir to the “FULL” mark and install the cap.
