CONTROLS/INSTRUMENTS/ACCESSORIES
The rotary beacon must be installed for road travel. See “Road travel” in the “Job Site and Road Operation” Section. STEP 3
PG02700
Remove the protective cap from the end of the tube located at the top of the cab. STEP 2
PG02702
Tighten the wingnut. The rotary beacon is turned on and off by the switch on the instrument panel. IMPORTANT: The rotary beacon must be on when travelling. IMPORTANT: When removing the rotary beacon, make sure to put the cap back on the end of the tube.
TRIM THIS EDGE
STEP 1
Alt= to hide template information Alt+ to display template information
ROTARY BEACON (specific to certain countries)
PG02702
Place the rotary beacon on the end of the tube.
107
TRIM THIS EDGE
RIGHT PAGE
Template Name: OM_1_col Template Date: 1994_04_29
NOTE: To replace the bulb see “Replacing a bulb” in the “Electrical System” Section.
