Y-7
Y-7
Assembly Adjustment (Traveling Device) Y-7
Assembly Adjustment (Traveling Device)
1.3 Check after replacing brake hose After you replace the brake hoses and so on,
1. Service brake adjustment
make sure that any contact does not occur between the hoses and the structures in any
1.1 Adjusting the brake pedal
situation. Check it with moving suspension (up
With the pedal weight causing the roller to contact
and down) and steering (right and left.)
the plunger, adjust the bolt until it contacts the
In addition, make sure that any hose is not twisted
stopper, then use the nut to lock it in place.
forcibly.
1.2 Tightening the cap of reserve tank of service brake fluid
2. Accelerator adjustment
After bleeding air, pour the brake fluid up to a
2.1 Accelerator pedal
required level, and tighten the cap until it stops at the stopper. At this time, the position of tank body and cap should be as shown in Fig.1. In addition, tighten the cap until the mark is aligned with the mark on tank as shown in Fig.2. The stopper might be broken when the cap is tightened too much.
32
WY05-3172E
