Lubrication Important: Use of lubricants not corresponding to manufacturer recommendations may invalidate warranty claims. Always dispose of waste lubrication oils and hydraulic fluids according to environmental laws or take to a recycling center for proper disposal. DO NOT pour fluids onto the ground or down a drain. Refer to the following figures for grease fitting locations. See “Fluid Capacities/Lubricants” on page 27 for proper grease specifications. Wipe dirt from the fittings before greasing them to prevent contamination. Replace any missing or damaged fittings. To minimize dirt build-up, avoid excessive greasing. 7
9 8
8
6 5 2
2
1
1
4
3
Figure 97 – Grease Every 10 Hours (or daily) (AL500 Series model shown) 1. All-Tach Pins (2) 2. All-Tach Pivots - Lower (2) 3. Lower Link Pivot - Front 4. Upper Link Pivot - Front 5. Lower Link Pivot - Rear
918444/AP0210
6. Loader Pivot 7. Tilt Cylinder - Front 8. LIft Cylinder - Front (2) 9. Upper Link Pivot - Rear
95
