GUZum_breva1100#06_##uk.book Page 26 Wednesday, March 8, 2006 6:14 PM
1 CONTROLS ON THE INSTRUMENT PANEL
NOTE The electric components only operate when the ignition switch is in the " " position. 1) “HAZARD” EMERGENCY PUSHBUTTON Press it to operate all four turn indicators and the corresponding lights on the instrument panel; the actual push-button is flashing. The HAZARD blinker stays on when the key is removed from the switch, but may not be turned off by simply pressing the hazard button again. Take the key to " " and press the push-button again to disable the Hazard function.
26
use and maintenance Breva
2 2) ABS DISABLING PUSH-BUTTON (only for vehicles equipped with ABS ABS ) Disable the system as follows: u Set ignition switch to " ". u Press and hold the SET (2) push-button for several seconds. After about three seconds the light ( ABS ) on the instrument panel will start blinking. u Immediately release push-button (2). u Now the ABS light on the panel will carry on blinking slowly meaning that the ABS is completely disabled. Re-enable the ABS as follows: u Stop the vehicle and the engine setting the ignition switch to " ".
3 u Take the switch back to ≈
≈ and start the engine. u With engine running, the ABS will be reenabled when speed gets above 5 km/h.
NOTE In case of failure or when ABS is disabled, the motorcycle acts as if it is not equipped with this system. 3) HEATED HANDGRIPS PUSHBUTTON OPT Press for several seconds to activate handgrips heating. Press briefly to adjust heating. Press again for several seconds to turn heating off. When the engine is stopped, the handgrip heating switches off, too; it will turn on again when the engine is started again, and will be set to last selected power level.
