REMOVING THE BATTERY

2 1

u Make sure that the cable terminals and the battery terminals are: √ in good condition (and not corroded or covered with deposits); √ covered with neutral grease or Vaseline.

If necessary:

u Remove the battery, see (REMOVING

THE BATTERY), in this page. u Clean off cable and battery terminals with a wire brush to remove all traces of corrosion. u Install the battery, see page 78 (INSTALLING THE BATTERY). REMOVING THE BATTERY

CAUTION

Removing the battery resets the following functions: digital clock, trip info and lap times. To re-set these functions, see page 17 (MULTIFUNCTION LCD DISPLAY).

Carefully read page 75 (BATTERY).

u Make sure that the ignition switch is in position ≈ ∆ . u Remove the rider seat, see page 29 (UNLOCKING/LOCKING THE SEAT). u Loosen the two screws (1) and move aside the cover (2).