TRANSMISSION
L2501, WSM
4. CHECKING AND ADJUSTING [1] MANUAL TRANSMISSION TYPE (1) Range Gear Shift Lever CAUTION • Park the tractor on a firm and level ground and set the parking brake. • Lower the loader and other implement to the ground. • Stop the engine, and remove the key. When shifting slowly the range gear shift lever from the position H (High) to the position N (Neutral), the gear inside sometimes remains at the position H and does not move, although the range gear shift lever is at the position N. It has been caused by a bad adjustment of the turnbuckle. Please verify and adjust the turnbuckle as follows. 9Y1211121TRS0001US0
Checking Range Gear Shift Lever Neutral Position 1. Shift the range gear shift level to N (Neutral) position on the H (High) speed side. Keeping the lever slightly being pushed forward (to the left of the photo), measure the overlapping length "A" of the level and guide. 2. Judgement [1] CORRECT Length "A" is 1 to 5 mm (0.04 to 0.1 in.) when the guide and lever are overlapping. [2] INCORRECT The overlapping length "A" is less than 1 mm (0.04 in.), or when there is a clearance between the guide and lever. In this case, carry out the following adjustment. A: P:
Overlapping length of the level and guide. The free play stroke of range lever.
a: b: c:
The forward position of range lever in neutral position. The backward position of range lever in neutral position. The end of the guide. 9Y1211121TRS0002US0
3-S8
KiSC issued 09, 2014 A
