BI632977
_______________________________________________________ Operation Daily starting procedure After reading the previous descriptions and locating each control, the operator is ready to operate the feeder breaker. An experienced operator should monitor a new operator’s indoctrination to the starting procedure. WARNING! The machine should not be started if it’s core temperature is below 30° Fahrenheit. If the machine is started at extremely low temperatures pump and pump motor failure could occur. IMPORTANT! Before start-up, check that daily maintenance has been performed on the machine. Operate all valve control levers to ensure that they are free and in neutral position. Check conveyor for any foreign material or objects. Check that all other personnel are within a safe distance of the machine. WARNING! Before start-up, check the conveyor for any foreign material or objects and that all other personnel are within a safe distance of the machine. Apply power to the machine. (Line side of the main circuit breaker) Set main circuit breaker located on the door of the starter enclosure by first moving the circuit breaker lever to the “RESET” position and then to the “ON” position.
Remote tram - Cattron Radio safety features (toggle controller) switch diagnostic mode
In this mode the operator can easily check that all function switches (motion and non-motion) are all fully operational. WARNING! Electrical power to the feeder breaker MUST BE COMPLETELY ISOLATED to prevent operation under remote control in the switch diagnostic mode. Failure to comply with the above WARNING may result in the undesired operation of the feeder breaker which in turn, could result in SERIOUS INJURY OR DEATH to personnel and damage to the feeder breaker.
______________________________________________________________ REV 2 5.17
