LUBRICATION/FILTERS/FLUIDS
NOTE : Do not use compressed air if there is oil or soot on the primary element.
PDE0378
PDE0088
If the primary element is oily : Clean it in water with a suitable detergent (consult your CASE Dealer). Instructions for using the detergent are printed on the packaging. IMPORTANT : Allow the primary element to dry completely before installing. It is advisable to keep a spare, clean the primary element ready for installation while the other primary element is drying.
IMPORTANT : Replace the primary element if light can be seen through a hole, however small.
Installing the elements STEP 1
CP99B012
Install the secondary element and tighten the wing nut.
159
TRIM THIS EDGE RIGHT PAGE
TRIM THIS EDGE
Check the primary element for damage by placing an inspection lamp inside the element.
Alt= to hide template information Alt+ to display template information
Inspecting the primary element
Template Name: OM_1_col Template Date: 1994_04_29
IMPORTANT : Compressed air pressure should not exceed 7 bar.
