ELECTRICAL
REMOVAL FROM STORAGE 1. Fill the fuel tank.
7. Install a fully charged battery.
2. Put coolant into the engine cooling system.
8. Remove air from the engine fuel lines.
3. Check the engine oil level. 4. Check the condition of the engine fan belt and replace if required.
IMPORTANT: Before starting the engine, make sure there are no leaks, missing or broken parts. 9. Start the engine and run at idle speed for 2 minutes. Check for leaks around the filters and drain plugs.
5. Check the hydraulic fluid level. 6. Use a petroleum base solvent and remove the Case Rust and Co rro sio n Pr eve ntive fr om th e hydraulic cylinder rods and spools, etc.
TRIM THIS EDGE
10. Stop the engine and check the fluid levels of the engine cooling system and drive chain compartments. See the Engine Cooling System an d Drive C hain C ompa rtme nt sections for the correct procedure on checking the fluid levels.
118
TRIM THIS EDGE LEFT PAGE Bur 9-25773
