INSTRUMENT PANEL

1 2 3 4 5 6 7

11 10 9 8

BP96C051 NOTE: When the key switch is turned ON, the warning lamps will illuminate for 2 seconds. If the warning lamps do not illuminate, see the service manual for this machine or see your Case dealer. If all systems are normal, the green Systems Normal lamp is illuminated. If any yellow warning lamp illuminates, stop at the end of the day or shift and correct the problem. If any red warning lamp illuminates, stop the machine and correct the problem immediately. 1. FUEL LEVEL GAUGE: This gauge indicates the amount of fuel in the fuel tank when the key switch is in the ON position. The symbols indicate full fuel tank, half full fuel tank, or empty fuel tank. The bottom lamp will start to flash when there are 4.3 UK gallons (19.6 litres) of fuel remaining in the fuel tank.

From this point on the machine can be operated for approximately 2 hours before the fuel tank is empty. 2. SYSTEMS NORMAL INDICATOR LAMP (Green): This lamp illuminates and stays illuminated during machine operation, or until one or more of the following condition occur; low engine oil pressure, high hydraulic fluid temperature, low alternator output, system voltage below 11 volts, high engine coolant temperature. 3. HYDRAULIC FILTER WARNING LAMP (Yellow): This lamp illuminates when the engine is started and the hydraulic fluid is cold, or when the engine is running and the hydraulic filter is in need of service. If the lamp is illuminated after 15 minutes of machine operation, or if the lamp illuminates during machine operation, stop the engine and service the hydraulic filter. If the lamp illuminates, it will not affect the Systems Normal indicator lamp and warning alarm.

4. ENGINE OIL PRESSURE WARNING LAMP (Red): This lamp illuminates when the engine is running and the engine oil pressure is too low. Then, the warning alarm will actuate and the Systems Normal indicator lamp will go out.

Stop the engine and check for the problem immediately. 5. ENGINE TEMPERATURE WARNING LAMP (Red): This lamp illuminates when the engine is running and the engine temperature is too high. Then, the warning alarm will actuate and the Systems Normal indicator lamp will go out.

Stop the engine and check for the problem immediately. 6. BATTERY WARNING LAMP (Red): This lamp illuminates and the warning alarm sounds when the battery voltage falls below 11 volts. The Systems

Normal indicator lamp will go out. 7.HOURMETER: The hourmeter shows the total hours of engine operation in hours and tenths of an hour. Use the hourmeter to measure the intervals between maintenance.

8. SEAT BELT WARNING LAMP (Red): When the engine is started, this warning lamp illuminates for five seconds, the warning alarm will actuate for five seconds and the Systems Normal indicator lamp will go out for five seconds.

9. HYDRAULIC TEMPERATURE WARNING LAMP (Red): This warning lamp illuminates when the engine is running and the hydraulic fluid temperature is too high. Then the warning alarm will actuate and the Systems Normal indicator lamp will go out. Stop the machine and check for the problem immediately. 10. CHARGE PRESSURE WARNING LAMP (Red): This lamp illuminates when the engine is running and the transmission charge pressure is too low. Then the warning alarm will actuate and the Systems Normal indicator lamp will go out. Stop the machine and check for the problem. 11. AIR FILTER WARNING LAMP (Yellow): This warning lamp illuminates when the engine is running and the air filter requires service. NOTE: If a problem is indicated, correct the problem. After correcting the problem, start the engine. The warning lamps will go out, the warning alarm will stop and the Systems Normal indicator lamp will illuminate.