DOperation

1Safety regulations

Injury or death can result whenever the engine, travel drive, milling drum, conveyor or lifting units are engaged.

When operating the machine, therefore maintain strict compliance with the sections of these operating instructions and the safety specifications dealing with personal conduct.

Before starting up, ensure that no-one is working in or under the vehicle, and that no-one is in the immediate danger area!

-Do not start up the engine and do not use any of the controls if there is a notice specifically prohibiting their use!

Unless otherwise specified, only operate the controls when the engine is running!

-Check thoroughly before starting the machine. Ensure that the machine status and position as well as the position of all safeguards, operating and adjustment fixtures permit the machine to be started safely.

-Sound the horn as a warning before starting the machine.

When the drive unit is operating, never step under the vehicle. Do not stand in the danger area of the vehicle unless absolutely necessary. Danger of death!

-While the equipment is operating, maintain a continuous check to ensure that noone is in danger!

-Ensure that all guards and covers are in place and have been secured properly!

-Remedy any damage detected without delay! Operation is prohibited in the event of defects!

-Do not allow unauthorised people to travel on the machine.

-Clear all obstacles off the road surface and out of the working area!

-Always endeavour to select a position for the driver which places him/her on the nearside, i.e. away from road traffic! Lock the control panel and driver’s seat in position.

-Maintain an adequate safety distance from overhangs, other equipment and other danger areas!

-On uneven ground, drive carefully to prevent slipping, tilting or overturning.

Always keep the vehicle under careful control. Never attempt to load it beyond its capacity limits!

ItemDesignationBrief description

1 Operating panels, operator’s control station

Positioned on the operator’s control station, easy to move out beyond the outer edge of the vehicle, can be locked on the right or left. Height is adjustable for ease of operation whether standing or sitting. Contain all the operating and control elements needed to manage the cold planer.

2 Control and monitoring unit

Positioned between the two operating panels for easy viewing. All the control and display elements needed for safe and faultless machine operations can be found here.

3 Front operating units

Operating unit - positioned in front of the milling drum housing, identical on both sides of the machine. Contains duplicates of the controls on the operator’s control station which are needed to control the front function elements on the cold planer.

4 Rear operating units

Operating unit arranged behind the planer box, identical on both sides of the machine. Contains duplicates of the controls on the operator’s control station which are needed to control the rear function elements on the cold planer as well as one removable digital controller each for the milling depth and slope position setting.