10.15. Basic setting (initialisation

10.15 Basic setting (initialisation)

After a repair to the sensors or in the event of a functional fault in the control system, the basic settings must be re-established (initialisation). In the initialisation mode the control system learns the individual end stop positions. At the same time, the settings for loading and unloading are reset back to the basic settings.

Danger!

Always work on the machine with the engine switched off. – Switch off engine. – Remove the ignition key.

Before starting initialisation the following conditions must be met: • The tractor and mounted machine must be standing on flat ground.

Removing the machine, see page 14. • There is enough space around the machine so that the tailgate can be opened and closed without presenting any danger. • The tractor is secured against rolling away. • The PTO shaft is switched off. • The hydraulic system is switched to pressure (only on tractors without load sensing system).