DOS Flash Utility Perform the following steps to use the DOS Flash Utility: 1.
Press F2 during boot to enter the Setup Menu.
2.
Select Boot Menu to modify the boot priority order, for example, if using USB HDD to Update BIOS, move USB HDD to position 1.
Information
Main
Advanced
InsydeH20 Setup Utility Security Power Boot Exit
Rev. 3.5 Item Specific Help
Boot priority order: 1. 2. 3. 4. 5. 6.
IDE0 : WDC WD2500BEVT-22ZCT0 IDE1 : TSSTcorp CDDVDW TS-U633A USB FDD : Network Boot : Realtek Boot Agent USB HDD : USB CDROM :
F1 Help ESC Exit
3.
Select Item Select Menu
F 5 / F 6 C h a n g e Va l u e s SubMenu Enter Select
Use < > or < > to select a device, then press <F5> to move it down the list, or <F6> to move it up the list. Press <Esc> to escape the menu
F9 F 10
Setup Default Save and Exit
Execute the FLASH.BAT batch file to update BIOS.
The flash process begins as shown.
4. In flash BIOS, the message Please do not remove AC Power Source displays. NOTE: If the AC power is not connected, the following message displays.
Plug in the AC power to continue. 5.
Flash is complete when the message Flash programming complete displays.
Chapter 2
35
