DOS Flash Utility

Perform the following steps to use the DOS Flash Utility: 1. Press F2 during boot to enter the Setup Menu. 2. Select Boot Menu to modify the boot priority order, for example, if using USB HDD to Update BIOS, move

USB HDD to position 1.

3. Execute the FLASH.BAT batch file to update BIOS. The flash process begins as shown.

InsydeH20 Setup Utility Rev. 3.5 Information Advanced Main Boot Security Power Exit

Boot priority order: Boot priority order: ItemSpecificHelp

Use < > or < > to select a device, then press <F5> to move it down the list, or <F6> to move it up the list. Press <Esc> to escape the menu

1. IDE0 : WDC WD2500BEVT-22ZCT0 1. IDE0 : WDC WD2500BEVT-22ZCT0 2. IDE1 : TSSTcorp CDDVDW TS-U633A 2. IDE1 : TSSTcorp CDDVDW TS-U633A 3. USB FDD : 3. USB FDD : 4. Network Boot : Realtek Boot Agent 4. Network Boot : Realtek Boot Agent 5. USB HDD : 5. USB HDD : 6. USB CDROM : 6. USB CDROM :

F1 ESC Help Exit Select Item Select Menu F5/F6 Enter ChangeValues Select SubMenu F9 F10 SetupDefault SaveandExit

4. In flash BIOS, the message Please do not remove AC Power Source displays. NOTE: If the AC power is not connected, the following message displays.

Plug in the AC power to continue. 5. Flash is complete when the message Flash programming complete displays.