Bringing out of storage ●
Check oil level in the engine and drive/reverse gear. Top up if required. For oil quality: See chapter Technical Data.
●
Note! If there is inhibiting oil in the system drain and fill with new oil, change the filters.
Immediately before launching the drive’s sacrificial anodes must be cleaned off with emery paper. If an anode is 2/3 its original size (1/3 eroded), it should be replaced. IMPORTANT Do not use steel brushes or any steel tools for cleaning the anodes. This can result in reduced galvanic protection.
Close/tighten drain cocks/plugs.
●
Check belts.
●
Reinstall the propeller(s).
●
Check condition of rubber hoses and tighten hose clamps.
●
●
Connect up the charged batteries.
Launch the boat. Check there is not fuel, water or exhaust leakage. Check that all control functions are operating normally.
●
Paint drive and hull: See following section.
7738812 - Downloaded from www.volvopenta.com 7/10/2006 5:02:36 AM
●
76
