Bringing out of storage

● Check oil level in the engine and drive/reverse gear. Top up if required. For oil quality: See chapter Technical Data.

Note! If there is inhibiting oil in the system drain and fill with new oil, change the filters.

● Close/tighten drain cocks/plugs.

● Check belts.

● Check condition of rubber hoses and tighten hose clamps.

● Connect up the charged batteries.

● Paint drive and hull: See following section. ● Immediately before launching the drive’s sacrificial anodes must be cleaned off with emery paper. If an anode is 2/3 its original size (1/3 eroded), it should be replaced.

IMPORTANT Do not use steel brushes or any steel tools for cleaning the anodes. This can result in reduced galvanic protection.

● Reinstall the propeller(s).

● Launch the boat. Check there is not fuel, water or exhaust leakage. Check that all control functions are operating normally.