436-3 WARRANTY Rex Chainbelt Inc. warrants products of its manufac-
All machines carry a machine Serial Number. The ma-
ture against defects in workmanship and material for a
chine Serial Number Plate is located on the left side of
period of six months from date of shipment to customer
the steering wheel mount. Always supply the machine
and in consequence of this warranty, any componant
Serial Number when referring to machine or ordering re-
part or parts of such products proving defective within
pair parts. Order repair parts through your Rex Dis-
the above specified time will be repaired or replaced
tributor being specific on shipping instructions.
F.O.B. factory, providing such parts are returned, transportation prepaid, to the factory and found defective by
OPERATION
Rex Chainbelt Inc. This warranty will not apply to any
Before starting — a complete lubrication check of the
product which shall have been repaired or altered out-
machine should be made in accordance with the lubri-
side of Chainbelt's factory in any way so as, in Chain-
cation chart; engine oil level, radiator coolant, hydrau-
belt's judgement, to affect its stability, or reliability,
lic oil, air cleaner, etc. All grease fittings should be
nor which has been subjected to misuse, negligence or
lubricated.
accident.
A general tightening of all nuts and bolts should be
Rex Chainbelt's liability as a manufacturer is limited
made, inspect fuel lines, hydraulic lines and fittings
to the replacement of defective parts, and no allowance
for tightness to prevent leaks. Tire chart must be
will be made for labor performed, delays or expense
checked for minimum and maximum pressure for ply
incident to the replacement of defective parts nor for
used. Refer to tire chart. Fill fuel tank in accordance
any consequential damages or injuries.
with engine manufacturer's specifications shown in engine manual.
Rex Chainbelt Inc. assumes no responsibility for engines, electrical equipment or any other equipment and accessories not manufactured by Rex Chainbelt Inc. beyond the warranty of the manufacturer of such equipment or accessories. Rex Chainbelt Inc. reserves the right to make changes
Also before starting, the operator should familiarize himself with the proper starting and engine operating procedure as outlined in the engine manual.
TO START (FIGS. 2 & 2A)
in design from time to time as are deemed desirable
1. Set parking brake. Push brake down to set.
without incurring the obligation to furnish them for machines previously sold or shipped.
2. Place the 4-speed transmission in neutral.
CHECK FOR SHORTAGE OR DAMAGE Upon receipt of equipment, a visual inspection should be made. While the equipment is in transit, any delay or damage to it is the responsibility of the carrier, therefore, before unloading from car or truck, a check for shortages or damages should be made. In the event of either, a representative of the carrier must make a full description of the shortage or damage on the freight bill. Any claims for shortages or damages must be made by you to the transportation company.
3. Turn key and start engine. Use throttle-shift control to increase engine speed for warm-up. 4. Place throttle-shift control in neutral. 5. Select and shift to desired gear in 4-speed transmission. 6. Release parking brake. 7. Move throttle-shift control in desired direction.
STEERING The Rexpac is directionally controlled by means of a standard steering wheel turned in the conventional manner. The steering wheel is connected directly to an ORBITROL rotary servo control. A hydraulic pump, belt driven from the engine provides the oil flow and pressure to the servo control at the steering wheel and is directed to the power steering cylinder at the front by means of two hydraulic lines. There are no mechanical connections in this full fluid steering system. In the event of an engine failure or
FIGURE 1
for emergency steering conditions, the ORBITROL auto-
