1 minute read
ME12002HYDRAULICSYSTEM
4.Using a driver and a hammer, remove shaft seal (24) from housing (22). See Figure 3-281.
IMPORTANT:Do not reuse shaft seal (24) after removing it.
DisassemblingtheCylinder
1.Remove the inner-race plate from tapered roller bearing (1). See Figure 3-281.
2.Set a gear extractor at two places of the innerrace plate of the tapered roller bearing and the spline end of the cylinder drum (16).
3.Remove the inner-race plate of tapered roller bearing (1). See Figure 3-281.
5.Remove sliding disk (20) from piston (18). See Figure 3-282.
IMPORTANT:Be sure to avoid damaging the sliding face of sliding disk (20).
4.Remove sliding disk (20), piston (18) and piston centering plate (19) from cylinder drum (16). See Figure 3-282.
6.Remove locking ring (17) from cylinder (16). See Figure 3-283.
