HYDRAULICSYSTEMME12002

12.Install piston (224) into casing (102) as shown, and in the same position as written down during step 19 of “Disassembling the Pilot Control Pedal” on page171.

16.Install grease cap (203) into plug (202). See Figure 3-250.

13.Install O-ring (212) onto plug (202) as shown. See Figure 3-248.

14.Apply a light coating of grease to packing (210).

17.Install push rod (214) into plug (202). Apply working oil to surfaces before fitting push rod. There is a risk of damage to the rib part of packing (210); do not use excessive force when fitting. See Figure 3-251.

15.Install packing (210) into plug (202) as shown. See Figure 3-249.

NOTICE:Be sure that packing (210) is in the correct orientation prior to installation. See Figure 3-249.

18.Install the push rod subassembly into casing (102).