ME12002HYDRAULICSYSTEM

7.Install the pressure reduction valve sub-assembly, assembled during steps 1 through 6, into casing (101), in the same position as written down during step 27 of “Disassembling the Pilot Control Pedal” on page171. See Figure 3-242.

IMPORTANT:Do not damage the lower end of the spool by hitting the lower end of the spool against the casing edge when installing the pressure reduction valve subassembly.

10.Install spring washer (218) into casing (102), using a tweezers as shown, and in the same position as written down during step 23 of “Disassembling the Pilot Control Pedal” on page171. See Figure 3-245.

8.Install O-rings (211, 213) into casing (101). See Figure 3-243.

9.Install upper casing (102) into a vice and install steel ball (225). See Figure 3-244.

11.Install spring (336) into casing (102) as shown, and in the same position as written down during step 21 of “Disassembling the Pilot Control Pedal” on page171.

IMPORTANT:Do not damage spring washer (218) during installation.