CHAPTER 3
Remove Dealer’s File Copy at Perforation
CHECKLISTS PRE-DELIVERY
DELIVERY CHECKLIST
After the Impeller Disc Mower Conditioner has been completely set-up, the following inspections MUST be made before delivering it to the Customer. Check off each item after prescribed action is taken.
The following Checklist is an important reminder of valuable information that MUST be passed on to the Customer at the time the unit is delivered. Check off each item as you explain it to this Customer.
Check that:
the Operator’s Manual to the Customer. Instruct o Give him/her to be sure to read and completely understand its
o o o o o o o
Disc Mower Conditioner has been completely and properly set-up according to instructions included with the unit. All grease fittings have been properly lubricated and the gearboxes and cutterbar have been filled to their proper operating levels. See the Lubrication chapter. All guards, shields and decals are in place and securely attached. All fasteners are properly secured. All adjustments have been made to comply with settings given in the Adjustments chapter. Tires are properly mounted and are inflated to 30 psi (210 kPa). Record the Model and Serial Numbers of this unit on this page and page 2.
contents BEFORE attempting to operate the unit.
and review all the SAFETY information with the o Explain Customer. that regular lubrication is required for continued o Explain proper operation and long life. Review the Lubrication chapter in this manual with the Customer, emphasizing that the oil in the cutterbar and the gearboxes MUST be changed after the first 10 hours of operation.
the function of the overrunning and slip clutch on o Explain the gearbox input to the Customer. that unit components may continue to rotate after o Explain the tractor PTO is disengaged and the customer MUST wait for all movement to stop BEFORE approaching the unit.
Connect the Disc Mower Conditioner to a 1000 RPM PTO and test-run the unit while checking that proper operation is exhibited by all components.
the function and use of the transport locks for the o Explain header lift and hydraulic drawbar positioner to the Customer.
Check that:
the proper use of the locking couplers on o Demonstrate both ends of the telescoping PTO drive to the Customer.
o All blades, discs and the rotor are turning freely. o All mechanisms are operating smoothly. hydraulic hose connections are NOT leaking under o The pressure and the lift mechanism is operating smoothly and o
fill out Owner’s registration, including cuso Completely tomer’s signature, and return it to the Company.
properly. The transport lights operate and signal left and right properly.
o Explain when a tire bumper extension kit is needed.
I acknowledge that the above points were reviewed with me at the time of delivery.
I acknowledge that pre-delivery service was performed on this unit as outlined above. Dealership’s Name
Customer’s Signature
Dealer Representative’s Name
Date Delivered
Date Checklist Filled out Model Number
Printed in U.S.A.
(Dealer’s File Copy)
Serial Number
5
909871/BP0603
