6.3 Operating the Roller
6. Make sure the throttle control is turned to low position.
Operation 1. Before the roller start-up, a pre-operational general inspection of the roller must be performed in accordance with those instructions previously mentioned and, in the instructions, found in section 7 - Maintenance.
Figure 6-5: Throttle control
2. Make sure all operator console controls are either off or in the neutral position and all control console gauges read zero.
Figure 6-4: Operator Consoles
7. Set the vibration switch for Front or both drum selection on forward/reverse lever. The operator must activate the work mode in key pad.
A
Emergency stop
C
Ignition switch
B
FNR lever
D
Throttle lever
Figure 6-6: Vibration Rear/Both drum selection Switches
3. Make sure the emergency stop button is not activated. 4. The FNR must be in neutral position. 5. Parking brake switch must be in engaged condition.
A
A Vibration Activation switch B Drum Selection switch
Inspections and Operations
38
