1 minute read
Assembling steering cylinder (without CLAAS 4-Trac-System) up to serial no....) ....................................................... 11.5
B
K 6
7
24 C
23
10
D 7
Pull off the sealing plate(6) carefully. Remove the sealing compound(B). (Fig.5,9)
Carefully pull the capillary tube(K) out of the evaporator(7).
5
6 Attention!
Force should never be used to remove the capillary tube(K) and it should not be bent over.
(Fig.6,9)
Unscrew the holding plate(C). Pull out the suction pipe(23) and the pressure pipe(24) and close the ends off with plugs. (Fig.7,9)
Remove the holding plate(D). Pull the expansion valve(10) off and seal both connections off on each side using plugs. Pull the evaporator(7) out of the roof of the cab. (Fig.7,8,9)
7
8
Air conditioner (cab side) dismantled
1Self-tapping screw St 4.8x13-cDIN6928 2Angle 3Terminal 4Hose 5Wire mesh 6Sealing plate 7Evaporator 8Angle 9Round seal ring 17x1.8-nDIN3771 10Expansion valve 11Round seal ring 11.1 x1.78-nDIN3771 12Cable ring 13Cable ring 14Temperature switch 15Rotary knob 16Inserter 17Hex head screw ISO4014M6x45-8.8 18Contact washer A6 19Pipe clamp 20Pipe clamp 21Spacer ring 22Cable ring 23Hose line (suction line) 24Hose line (pressure line) 25Rubber bearing 26Fixing clamp 27Contact washer A8 28Hex head screw ISO4017 M8 x40-8.8 (Fig.9)
